Enter Zip Code where unit will be installed
Is made up of two units: an outside unit, referred to as the condenser, and an inside unit, usually referred to as the “air handler”. Refrigerant lines known as a “lineset” connect these two units. This is most common in Richmond VA area.
Is a system that contains both the Condenser and the Air Handler in one “Package”. These units sit on the ground or rooftop outside of your home or business.
Is a solo component that furnishes heat to the home. They are generally located in a basement, a closet or an attic. Gas systems burn natural gas for heat inside a furnace. If you receive a monthly gas bill, chances are you have a gas furnace.
Straight AC units are basic air conditioning.
Heat strips are added to give a system the ability to heat in the winter.
An electric Heat Pump uses refrigerant to both cool and heat the home.
If you have a natural gas bill, you likely have a gas furnace.
If not, your system is likely all electric.
The square footage estimator is generally accurate to picking the correct unit size. Keep in mind, every purchase has a pre-install job site inspection where your contractor will be able to verify that you ordered the correct unit, or make any necessary changes to insure you are replacing the correct unit size.
NOTE: If you have multiple AC units in your home, you can use the same square footage estimator based on how much area each unit covers. Your install contractor will verify during the job site inspection that you have ordered the correct tonnage, and assist with any necessary correction to your order prior to installation.